52CC Short Shaft Outboard Motor, 2.5 HP Gas Outboard Motor Boat Engine Electronic Ignition with Air Cooling System for Small Boats Under 9.8ft

<p><i><b>Specifications</b></i><br>Material: Plastic, Aluminium Alloy, Steel, Rubber<br>Type: 2 Stroke Engine, Air Cooling<br>Carburetor Type: Diaphragm Type<br>Cooling System: Forced Air Cooling<br>Mounting Type: ‎Boat Ramp Outboards<br>Gear: CVT ( Without Reverse Gear )<br>Ignition System: Electronic Ignition<br>Trim and Tilt System: Manual<br>Operation Mode: Manual CVT<br>Gasoline: Mixed Oil (25:1 Mix of Gasoline and Two-stroke Engine Oil) <br>Propeller Specification: 3-blade Aluminum Alloy( Diameter is 18cm/7.09in )<br>Shaft Length: Short Shaft (For Kneeling Board Within 45cm/17.72in From the Water Surface)<br>Displacement: 52cc<br>Horsepower: 2.5 HP<br>Fuel Tank Capacity: 1L/0.26gal<br>Fuel Consumption: 0.6-0.8L/0.16-0.21gal/hours<br>Power: 1.82kw <br>Rotation Speed: 8500rpm<br>Full Fuel Running Time: 40-70min<br>Applicable Boat Size: Within 3m/9.84ft<br>Gross Weight: 10.2kg/22.49lbs<br>Product Size: 25*24*107cm/9.84*9.44*42.12in<br>Operating Rod Length: 56cm/22.04in</p> <p><br><i><b>Notes</b></i><br>1.Two-stroke air-cooled engines must use TCW-2 engine oil, which must be specifically designed for outboard engines.<br>2.Fuel mixture ratio: 25:1 for the first 50 hours, 50:1 after 50 hours.<br>3.Two-stroke outboard engines must use a mixture of 92# gasoline and two-stroke engine oil.<br>4. During the break-in period, the volume ratio of gasoline to oil is 25:1. <br>5. After the break-in period, the volume ratio of gasoline to oil is 50:1. <br>6. Important note: Gasoline and oil must be pre-mixed and thoroughly stirred before being poured into the fuel tank. <br>7.The outboard motor must be started in water, please do not start the engine on land.<br>8.When starting the engine, loosen the vent screw on the fuel tank cap counterclockwise.<br>9.When starting the outboard motor, insert the emergency stop rope and secure the other end to your wrist or belt<br>10.The break-in period lasts approximately 10 hours or one month. Please avoid operating the engine at high throttle during the break-in period.<br>11.After the break-in period, replace the gear oil. The second replacement should be performed after approximately 100 hours or six months.<br>12.Please note that gearboxes are supplied with gear oil from the factory, but this needs to be changed regularly, depending on the frequency of use.<br>13.Please read the operating manual and label completely before use, and pay particular attention to the safety instructions included. Please note that the speed is certainly not the same when one person is on it or many people are on the boat. Please don't start the motor on the bank. If you want to test the motor, it should be done in the river. Please don't use the motor when it stops coming out of the water.<br>14.Please note that gasoline is prone to oxidation and degradation during storage. Using degraded gasoline can clog fuel lines and cause starting difficulties. If the engine has not been used for more than half a month, please drain the fuel, in advance.<br>15.Please note that the propeller can withstand fresh water, but we do not recommend using it in salt water.<br>16.Please prepare enough fuel according to the sailing distance. Please carry a life jacket and hand paddle (both not included). Please check the installation of the outboard motor before sailing.<br>17. Please note that all gasoline engines make noise, but this is normal. We recommend you prepare a boat-motor stand or hanging board (both not included) on your boat. The use of fishing gear should comply with national laws and regulations, comply with local government water control, protect the environment, and cherish the ecology.<br>18. If you need to accelerate, please accelerate slowly, please don't accelerate sharply or it will increase the wear and tear of the clutch.<br>19.Please note that if the product is not used for a long time, please fuel drain the excess fuel in the carburetor to improve the service life.</p>

• Application：It is suitable for small boats under 9.8ft. It is suitable for fishing, aquaculture, outdoor adventure, water sports, water tourism, water rescue, and other fields.

• Adjustable Design: You can turn the handle for rotary and reverse functions without the abruptness of shifting gears, while achieving infinitely variable speeds through the throttle valve to meet your different needs.

• Powerful Motor: It is a two-stroke 2.5-horsepower motor with a speed of up to 8500 rpm, allowing you to drive quickly, saving a lot of time and energy. When you fill it up with oil, it can run for 40-70 minutes.

• Good Heat Dissipation: The cooling holes in the housing dissipate heat quickly, preventing the motor from burning out after long periods of use. Meanwhile, the air cooling system allows for faster cooling, reducing the failure rate.

• Thoughtful Design: It is equipped with a sound reduction system, which creates a relatively quiet and comfortable environment for you. The toolkit bag can be used to store tools for servicing this product to avoid losing them. The funnel and fuel oil mixing bottle make it easier to add fuel.

• Electronic Ignition System&External Fuel Tank Design: This product adopts non-contact electronic ignition and manual activation, which is easy to start.The external 0.26gal fuel tank allows you to have a clearer view of the fuel volume inside, making it easy to control driving time and replenish fuel promptly.